#1 Le 27/10/2005, à 20:30
- christo
Breezy lent depuis installation eagle-usb
J'ai fait l'installation Ubuntu - Breezy sans problème
Système assez réactif avec un AMD Duron 750 MHz + 256 Mo de RAM
Depuis que j'ai installé eagle-usb 2.3.2, c'est d'une lenteur impressionante ! que ce soit en surfant ou en utilisant divers programme
j'ai une connexion ADSL 1024 chez Cegetel avec modem Fast@800
voici quelques infos
$ /etc/resolv.conf
nameserver 212.94.174.85
nameserver 212.94.174.86
$eaglediag -a
Diagnostic (1.22 2005/03/20) driver eagle-usb 20051027214808
# System Information
Linux semoy 2.6.12-9-386 #1 Mon Oct 10 13:14:36 BST 2005 i686 GNU/Linux
testing/unstable
Linux version 2.6.12-9-386 (buildd@rothera) (gcc version 3.4.5 20050809 (prerelease) (Ubuntu 3.4.4-6ubuntu8)) #1 Mon Oct 10 13:14:36 BST 2005
version gcc 4.0.2 20050808 (prerelease) (Ubuntu 4.0.1-4ubuntu9)
# Dependances
ppp 2.4.3-20050321+2ubuntu1 install ok installed
dhcp-client unknown ok not-installed
Aucun paquet ne correspond à dhcpcd.
lrwxrwxrwx 1 root src 22 2005-10-17 16:17 linux -> linux-headers-2.6.12-9
drwxr-xr-x 18 root root 4096 2005-10-17 15:04 linux-headers-2.6.12-9
drwxr-xr-x 4 root root 4096 2005-10-17 15:04 linux-headers-2.6.12-9-386
# Kernel config : usb modules
eagle_usb 115136 0
ppp_async 10240 1
ppp_generic 25748 5 ppp_async
slhc 6656 1 ppp_generic
crc_ccitt 2176 1 ppp_async
ehci_hcd 29448 0
uhci_hcd 28048 0
usbcore 104188 5 spca5xx,eagle_usb,ehci_hcd,uhci_hcd
# pci & usb configuration (check for latency, only keep relevant lines about USB)
0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 02)
0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP]
0000:00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 22)
0000:00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 10)
0000:00:07.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 10)
0000:00:07.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 10)
0000:00:07.4 Bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 30)
0000:00:0b.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 61)
0000:00:0b.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 61)
0000:00:0b.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 63)
0000:00:12.0 Multimedia audio controller: Ensoniq ES1371 [AudioPCI-97] (rev 02)
0000:01:00.0 VGA compatible controller: ATI Technologies Inc 3D Rage Pro AGP 1X/2X (rev 5c)
Bus 005 Device 001: ID 0000:0000
Bus 004 Device 002: ID 041e:401c Creative Technology, Ltd WebCam NX [PD1110]
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 002: ID 1110:9021 Analog Devices Canada, Ltd (Allied Telesyn)
Bus 001 Device 001: ID 0000:0000
# interruptions' affectation
CPU0
0: 1243458 XT-PIC timer
1: 2550 XT-PIC i8042
2: 0 XT-PIC cascade
7: 46 XT-PIC parport0
8: 1 XT-PIC rtc
10: 2686 XT-PIC uhci_hcd:usb3, Ensoniq AudioPCI
11: 305281 XT-PIC acpi, uhci_hcd:usb1, uhci_hcd:usb2, uhci_hcd:usb4, ehci_hcd:usb5
12: 40142 XT-PIC i8042
14: 24222 XT-PIC ide0
15: 2927 XT-PIC ide1
NMI: 0
LOC: 0
ERR: 0
MIS: 0
# disk uses dma ? [ OK ]
# module loaded ? [ OK ]
# modem operational ? [ OK ]
eagle-usb status display
-------------------------------------------------------------
Driver version 2.3.2 Chipset: Eagle0
Vendor ID : 0x1110 Product ID : 0x9021 Rev: 0x500b
USB Bus : 001 USB Device : 002 Dbg mask: 0x0
Ethernet Interface : eth0
MAC: 00:60:4c:29:ad:ce
Tx Rate 320 Rx Rate 1216
FEC 828 Margin 15 Atten 50 dB
VID-CPE 0 VID-CO 28 HEC 31
VPI 8 VCI 35 Delin GOOD
Cells Tx 20160 Cells Rx 38401
Pkts Tx 8697 Pkts Rx 8597
OAM 0 Bad VPI 0 Bad CRC 1
Oversiz. 0
Modem is operational
# Config vpi/vci/encapsulation/isp : 8 23 6 (pppoa) FR08
# pppd launched ? [ OK ]
# Service for connection [ OK ]
# /etc/resolv.conf should contain the DNS
nameserver 212.94.174.85
nameserver 212.94.174.86
eth0 Lien encap:Ethernet HWaddr 00:60:4C:29:AD:CE
adr inet6: fe80::260:4cff:fe29:adce/64 Scope:Lien
UP BROADCAST RUNNING MULTICAST MTU:65535 Metric:1
RX packets:8600 errors:0 dropped:0 overruns:0 frame:0
TX packets:8700 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:1470949 (1.4 MiB) TX bytes:679578 (663.6 KiB)
lo Lien encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
adr inet6: ::1/128 Scope:Hôte
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:14236 errors:0 dropped:0 overruns:0 frame:0
TX packets:14236 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:3172882 (3.0 MiB) TX bytes:3172882 (3.0 MiB)
ppp0 Lien encap:Protocole Point-à-Point
inet adr:80.125.121.31 P-t-P:80.125.120.1 Masque:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:8527 errors:0 dropped:0 overruns:0 frame:0
TX packets:8622 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:3
RX bytes:1452999 (1.3 MiB) TX bytes:504663 (492.8 KiB)
sit0 Lien encap:IPv6-dans-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Table de routage IP du noyau
Destination Passerelle Genmask Indic Metric Ref Use Iface
80.125.120.1 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
0.0.0.0 80.125.120.1 0.0.0.0 UG 0 0 0 ppp0
# ping IP ? [ OK ]
# test DNS resolution ? [ OK ]
Merci
#2 Le 10/05/2006, à 05:54
- mondsur
Re : Breezy lent depuis installation eagle-usb
Il y a un topic dans la documentation pour installer ce modem sous ubuntu, si je me rapelle bien tu dois installer debhelper par synaptic ; avant tu dois telecharger trois paquets. Pour moi cela a super bien marché ; tout est là je t'en dis pas plus
"http://doc.ubuntu-fr.org/materiel/modem_adsl_fast_800?s=eagle+usb"
Morgan
Hors ligne